Download
Table of Contents > Anti-lock brake system > Overview of fitting locations (ABS/ESP)

VW Tiguan Brake System ➜ Overview of fitting locations (ABS/ESP)

Tiguan 2021 ➤, Tiguan RUS 2021 ➤  
Brake system - Edition 10.2020  
2
Overview of fitting locations  
2.1  
Overview of fitting locations – ABS/ESP  
2. Overview of fitting locations  
13  
theMANUALS.org  
 
Tiguan 2021 ➤, Tiguan RUS 2021 ➤  
Brake system - Edition 10.2020  
1 - ABS control unit -J104-  
❑ Installation location: on  
hydraulic unit, on pas‐  
senger side of engine  
compartment.  
❑ Do not separate con‐  
nector before success‐  
fully completing self-di‐  
agnosis. Switch ignition  
off before separating  
connector.  
The following components are  
integrated into the control  
unit:  
♦ Control unit for electrome‐  
chanical parking brake -  
J540-  
♦ Lateral acceleration send‐  
er -G200-  
♦ Yaw rate sender -G202-  
♦ Longitudinal acceleration  
sender -G251- (depending  
on equipment fitted)  
♦ The components cannot  
be renewed individually.  
❑ Assembly overview ⇒  
page 16  
❑ Removing and instal‐  
ling ⇒ page 21  
2 - ABS hydraulic unit -N55-  
❑ Fitting location: on pas‐  
senger side of engine  
compartment  
The hydraulic unit consists of  
the components:  
♦ ABS hydraulic pump -V64-  
♦ Brake pressure sender -G201-  
♦ Valve block (contains inlet and outlet valves).  
❑ ABS hydraulic pump -V64- and valve block must not be separated from one another.  
❑ Assembly overview ⇒ page 16  
❑ Removing and installing ⇒ page 21  
3 - Brake pad warning lamp -K32-  
❑ Location: in dash panel insert  
4 - ABS warning lamp -K47-  
❑ Location: in dash panel insert  
5 - ESP and TCS warning lamp -K155-  
❑ Location: in dash panel insert  
6 - Brake system warning lamp -K118-  
❑ Location: in dash panel insert  
7 - Diagnostic connection  
❑ Location: Driver footwell cover.  
8 - Steering angle sender -G85-  
14  
Rep. gr.45 - Anti-lock brake system  
theMANUALS.org  
Tiguan 2021 ➤, Tiguan RUS 2021 ➤  
Brake system - Edition 10.2020  
❑ Fitting location: in steering rack.  
❑ The steering angle sender -G85- cannot be renewed separately.  
❑ Removing and installing steering ⇒ Running gear, axles, steering; Rep. gr. 48; Steering rack; Remov‐  
ing and installing steering rack.  
9 - Wheel hub with wheel bearing  
❑ ABS sensor ring is installed in wheel bearing  
10 - Front right/left speed sensor -G45-/-G47-  
❑ Removing and installing ⇒ page 42  
11 - Wheel hub with wheel bearing  
❑ ABS sensor ring is installed in wheel bearing  
12 - Rear right/left speed sensor -G44-/-G46-  
❑ Removing and installing ⇒ page 43  
13 - Brake servo  
❑ Assembly overview ⇒ page 96  
❑ Removing and installing ⇒ page 100  
14 - TCS and ESP button -E256-  
❑ Two versions, therefore two fitting locations:  
♦ Button in centre console  
♦ Function button in menu of infotainment system  
❑ Removing and installing TCS and ESP button -E256- in centre console ⇒ Electrical system; Rep.  
gr. 96; Controls; Removing and installing TCS and ESP button -E256-  
2. Overview of fitting locations  
15  
theMANUALS.org  

Need help?

If after viewing the owner's manual or service manual you still have some unresolved questions about the car VW Tiguan you can write to us using the link below, describing your problem in detail, we try to answer all questions.


Ask your question on the page - Support!