Tiguan 2016 ➤, Tiguan 2021 ➤, Tiguan RUS 2017 ➤, Tiguan RUS 2021 ➤
Maintenance - Edition 12.2020
All data required are shown on display.
Inspection
– Inspect all exhaust emissions relevant components.
– Check if exhaust system is fitted and complete and check for
leaks and damage.
Procedure
– Follow instructions from exhaust gas testing station.
5.2
Exhaust emissions test for diesel en‐
gines
Special tools and workshop equipment required
♦ Exhaust gas testing station L -VAS 7320 A-
Note
♦ The following description refers to vehicles fitted with “On‐
board diagnosis” OBD.
♦ The OBD monitors all components and part systems influ‐
encing the exhaust emissions quality.
♦ It is possible to carry out an exhaust emissions test only
when all units of the emissions testing station are connected
properly and joined to each other according to the operating
instructions.
♦ All work to be performed is displayed by the emissions test‐
ing station.
Conditions for testing
•
All test conditions and data required for exhaust emissions
test are found on EET data sheet for the respective engine.
•
•
•
•
Automatic gearbox: selector lever in “P” position
Manual gearbox: gear lever in neutral
Parking brake applied
12V battery fully charged (if battery charge is too low, raise
idling speed if necessary).
– Perform exhaust emissions test according to instructions on
display.
Vehicle data input
– Enter the following data:
♦ Registration number
♦ Key numbers
♦ Vehicle identification number
♦ Fuel type
♦ Mileage
The following vehicle data can be found in the vehicle registra‐
tion certificate part 1:
♦ Registration number: “e.g. WOB-HH 1234”
♦ Emission key No. “field 14.1 (code for field 14)”
♦ Vehicle manufacturer: “Field 2”, “Field 2.1 (code for field 2)”
5. Exhaust emissions test
185
Tiguan 2016 ➤, Tiguan 2021 ➤, Tiguan RUS 2017 ➤, Tiguan RUS 2021 ➤
Maintenance - Edition 12.2020
♦ Vehicle identification number “field E”
♦ Type and version “Field D2 (type only)”, “Field 2.2 (code for
field D.2)”
♦ Nominal speed “field P4”
Specified data input for EET
There are different ways to enter the specified data:
♦ 1. By manual input
♦ 2. By automatic data acceptance from the exhaust-emission
station database
Note
♦ Regarding Euro 6 vehicles with manual gearbox and info‐
tainment system, the deactivation of the idle speed limitation
♦ Euro 6 vehicles with automatic gearbox, manufactured from
week no. 48/18 do not have idle speed limitation any more.
♦ If there is no ESP or soft key in the infotainment system
to deactivate the speed limitation, the governed speed can
be measured using the engine speed limited by the control
unit. To do this, all the EET specifications must be entered
manually.
-1
♦
For all Euro 6 vehicles an opacity figure of max. 0.25 m
applies.
Deactivation of idle speed limitation of Euro 6 vehicles with
manual gearbox:
– Switch on ignition.
– Switch on infotainment system.
– Press Home function button.
– Press Vehicle function button.
– Press Setup function button.
– Press ESC system function button and deactivate TCS.
Manual specified data input for EET:
Note
♦ For the relevant test requirements and all the necessary da‐
ta for the exhaust emissions test, refer to the ⇒ Data sheets
for exhaust emissions test of the respective engine.
♦ The nominal speed is located in field P4 of the registration
certificate part 1 or field 7 of the vehicle document and must
always be entered manually.
♦ If the idle speed limitation cannot be deactivated, enter the
value 2500 ± 200 rpm in the box for rev limit and 2500 in the
box for engine speed for conditioning.
– Perform manual data input according to instructions on dis‐
play.
– Enter displayed values on EET data sheet in column “Test
values for exhaust emissions test” on display as follows:
186
5. Exhaust emissions test
Tiguan 2016 ➤, Tiguan 2021 ➤, Tiguan RUS 2017 ➤, Tiguan RUS 2021 ➤
Maintenance - Edition 12.2020
1 - Speed for conditioning
2 - Number of throttle bursts for conditioning
3 - Engine oil temperature (min. value)
4 - Select engine oil temperature measurement procedure
5 - Idling speed
6 - Governed speed
7 - Nominal speed (registration certification part 1, vehicle
document)
8 - Governed speed measuring period (1 second)
10 - Select probe type (No. of probe)
11 - Select measuring mode
12 - Measured period portion
Note
♦ When performing the exhaust emissions test for Euro 5 ve‐
hicles, the respective engineer must always use the vehicle-
specific exhaust emissions limit value indicated on the type
plate.
♦ If no value is indicated on the type plate, the opacity figure
specified by the manufacturer and indicated in ELSA must
be used.
♦ If no value is indicated on the type plate and no opacity
figure has been specified by the manufacturer, the statutory
-1
-1
opacity figures (2.5 m or 1.5 m , depending on date of
initial registration) must be used.
The nominal speed can only be entered manually.
If the opacity figure of Euro 5 vehicles on the EET data sheet
is different from the value indicated on the type plate, enter the
type plate value manually.
Inspection
– Inspect all exhaust emissions relevant components.
– Check if exhaust system is complete and check for leaks
and damage.
Procedure
– Follow instructions from exhaust gas testing station.
Evaluation
Note
If the exhaust emissions test was performed at idle speed
limitation, the log note “governed speed <90% of the nominal
speed (idle speed limitation)” is entered in the log.
5. Exhaust emissions test
187
Tiguan 2016 ➤, Tiguan 2021 ➤, Tiguan RUS 2017 ➤, Tiguan RUS 2021 ➤
Maintenance - Edition 12.2020
6
00 Periodic Technical Inspection
(PTI)
Note
♦ The following information is provided on the basis of the
Commission Implementing Regulation (EU) 2019/621 and is
intended solely as information for the regular roadworthiness
testing of motor vehicles.
♦ The information on maintenance is provided as usual in the
corresponding maintenance tables, and the activities to be
performed are described in detail in the “Maintenance Man‐
ual”.
188
6. 00 Periodic Technical Inspection (PTI)
2024 VW Tiguan Owner's Manual
