Download
Table of Contents > Bonnet > Tank flap unit

VW Tiguan Body Repairs Exterior ➜ Tank flap unit

lk  
Tiguan 2016 ➀ , Tiguan RUS 2017 ➀  
General body repairs, exterior - Edition 06.2017  
3
Tank flap unit  
β‡’ β€œ3.3 Removing and installing fuel tank flap”, page 97  
3.1  
Assembly overview - tank flap unit  
1 - Tank flap unit  
❑ Removing and installing  
2 - Tank flap  
❑ Removing and installing  
3 - Water drain hose  
❑ Routed between wheel  
housing and wheel  
housing liner  
4 - Tank filler flap locking motor  
- V155-  
❑ Removing and installing  
β‡’ page 159  
5 - Electrical connector  
6 - Bolts  
❑ Qty. 2  
❑ 1.5 Nm  
3.2  
Removing and installing tank flap unit  
Special tools and workshop equipment required  
94  
Rep. gr.55 - Bonnet, rear lid  
theMANUALS.org  
   
Tiguan 2016 ➀ , Tiguan RUS 2017 ➀  
General body repairs, exterior - Edition 06.2017  
♦ Radio release tool - T10057-  
Removing  
– Screw off tank cover.  
Note  
The removal and installation procedure for the tank flap unit on vehicles with reducing agent filler neck is no  
different than that shown here.  
3. Tank flap unit  
95  
theMANUALS.org  
Tiguan 2016 ➀ , Tiguan RUS 2017 ➀  
General body repairs, exterior - Edition 06.2017  
– Using radio release tool - T10057- , punch through tank flap  
unit at markings -2- -arrows a-.  
– Insert radio release tool - T10057- through these openings  
-2- until the notch is reached.  
Retaining hooks -3- -arrow b- are released.  
– Peel rubber grommet off fuel filler neck.  
– Swing tank flap unit -1- out of the side panel -arrow b-.  
– Pull out tank flap unit -1- towards the rear -arrow a-.  
– Guide water drainage hose -4- together with tank flap unit out  
of side panel.  
Installing  
Install in reverse order, noting the following:  
96  
Rep. gr.55 - Bonnet, rear lid  
theMANUALS.org  
Tiguan 2016 ➀ , Tiguan RUS 2017 ➀  
General body repairs, exterior - Edition 06.2017  
– Insert water drainage hose -4- through opening in tank flap unit  
-1- and then pull it through as far as it will go.  
– Push water drainage hose -4- into side panel.  
– Insert tank flap unit -1- in side panel -arrow a- and swing in  
-arrow b-.  
– Push tank flap unit -1- into side panel -arrow c- until retaining  
hooks -2- engage.  
– Pull sleeve over filler neck -3-.  
β€’
Check function of release components.  
3.3  
Removing and installing fuel tank flap  
Removing  
3. Tank flap unit  
97  
theMANUALS.org  
Tiguan 2016 ➀ , Tiguan RUS 2017 ➀  
General body repairs, exterior - Edition 06.2017  
– Push tank flap -1- out of catches of tank flap unit -2-  
-arrow a-.  
– Remove tank flap -arrows b-.  
Installing  
Install in reverse order, noting the following:  
98  
Rep. gr.55 - Bonnet, rear lid  
theMANUALS.org  
Tiguan 2016 ➀ , Tiguan RUS 2017 ➀  
General body repairs, exterior - Edition 06.2017  
lk  
– Position tank flap -1- on tank flap unit -2- -arrows a-.  
– Push tank flap into catches of tank flap unit -arrow b-.  
3. Tank flap unit  
99  
theMANUALS.org  

Need help?

If after viewing the owner's manual or service manual you still have some unresolved questions about the car VW Tiguan you can write to us using the link below, describing your problem in detail, we try to answer all questions.


Ask your question on the page - Support!