Download
Table of Contents > Lights, bulbs, switches - exterior > High-level brake light

VW Tiguan Electrical System ➜ High-level brake light

Tiguan 2016 ➤ , Tiguan RUS 2017 ➤  
Electrical system - Edition 11.2018  
5
High-level brake light  
5.1  
Assembly overview - high-level brake light  
1 - Connector for brake light  
2 - Connection for washer fluid  
hose  
3 - High-level brake light  
❑ With high-level brake  
light bulb - M25-  
Removing and installing  
5.2  
Removing and installing high-level  
brake light  
Special tools and workshop equipment required  
156  
Rep. gr.94 - Lights, bulbs, switches - exGteriEorTtheMANUALS.org  
   
Tiguan 2016 ➤ , Tiguan RUS 2017 ➤  
Electrical system - Edition 11.2018  
♦ Plastic wedge - T10039/1-  
Removing  
– Switch off ignition and all electrical consumers.  
– Keep the ignition key outside the vehicle to prevent the ignition  
from being switched on unintentionally.  
Caution  
Danger of damage to component surfaces.  
♦ When using leverage tools, mask visible areas of the com‐  
ponent with commercially available adhesive tape.  
– Attach a strip of adhesive tape -1- to rear lid area above high-  
level brake light.  
Caution  
Make sure the seal is not damaged when removing the high-  
level brake light.  
– Insert plastic wedge - T10039/1- -1- at top between high-level  
brake light -2- and rear lid.  
– Press down high-level brake light -2- using plastic wedge -  
T10039/1- .  
– Swing high-level brake light -2- out of rear lid.  
5. High-level brake light  
157  
theMANUALS.org  
Tiguan 2016 ➤ , Tiguan RUS 2017 ➤  
Electrical system - Edition 11.2018  
– Pull out hose-locking device -arrow-.  
– Pull hose connection -1- off high-level brake light.  
– Disconnect electrical connector -2-.  
– Remove high-level brake light.  
Installing  
Install in the reverse order of removal, observing the following:  
Note  
If the event of a defective LED, the entire high-level brake light  
needs to be renewed.  
When installing high-level brake light, make sure seal is cor‐  
rectly seated. The seal must not form loops or be damaged.  
When connecting the washer fluid line, ensure that the secur‐  
ing clip engages audibly in the connection.  
– Connect hose connection and connectors.  
– Guide high-level brake light into rear lid.  
– Engage locking devices at top.  
– Engage retaining springs at bottom.  
– Check high-level brake light and rear window washer system  
for fault-free operation.  
158  
Rep. gr.94 - Lights, bulbs, switches - exGteriEorTtheMANUALS.org  

Need help?

If after viewing the owner's manual or service manual you still have some unresolved questions about the car VW Tiguan you can write to us using the link below, describing your problem in detail, we try to answer all questions.


Ask your question on the page - Support!