Download
Table of Contents > Lights, bulbs, switches - interior > Lights - Removing and installing

VW Tiguan Electrical System ➜ Lights - Removing and installing

Tiguan 2016 ➀ , Tiguan RUS 2017 ➀  
Electrical system - Edition 11.2018  
1.6.2  
Overview of fitting locations – lights in roof trim, with panorama tilting sunroof  
1 - Illuminated vanity mirror -  
W14- / -W20-  
❑ Front passenger side il‐  
luminated vanity mirror -  
W14-  
❑ Driver side illuminated  
vanity mirror - W20-  
❑ Removing and installing  
β‡’ page 226  
2 - Front interior light - WX1-  
❑ With driver side reading  
light - W19- and front  
passenger reading light  
- W13-  
❑ Removing and installing  
β‡’ page 258  
❑ Removing and installing  
bulb for front interior  
light - WX1-  
β‡’ page 227  
❑ Removing and installing  
bulb for front passenger  
reading light - W13- /  
driver side reading light  
- W19- β‡’ page 230  
3 - Rear interior light -W47- / -  
W48-  
❑ Rear left interior light -  
W47-  
❑ Rear right interior light -  
W48-  
❑ Removing and installing  
β‡’ page 261  
❑ Bulb for rear interior light  
-W47- / -W48-  
β‡’ page 231  
4 - Roof ambient lighting bulb -W76- / -W77-  
❑ Roof ambient lighting bulb, left - W76-  
❑ Roof ambient lighting bulb, right - W77-  
❑ Removing and installing β‡’ page 223  
1.7  
Removing and installing glove compart‐  
ment light - W6-  
Removing  
– Turn light switch to zero position.  
1. Lights  
217  
theMANUALS.org  
Tiguan 2016 ➀ , Tiguan RUS 2017 ➀  
Electrical system - Edition 11.2018  
– Press in locking lug -1- using a flat screwdriver, and lever out  
glove compartment light -2-.  
– Release and disconnect electrical connector -3-.  
Installing  
Install in the reverse order of removal, observing the following:  
Note  
If an LED glove compartment light - W6- is faulty, the entire light  
must be renewed.  
– Insert glove compartment light into opening and engage it on  
opposite side.  
– Perform functional check.  
1.8  
Replacing bulb for glove compartment  
light - W6-  
Note  
If an LED glove compartment light - W6- is faulty, the entire light  
must be renewed.  
Removing  
– Remove glove compartment light - W6- β‡’ page 217 .  
– Lever off heat shield -2- on both sides at arrows -A-.  
– Remove heat shield -2- from glove compartment light - W6-  
-1-.  
– Pull bulb -1- out of bulb holder -2- on reverse side of glove  
compartment light.  
Installing  
Install in reverse order of removal.  
218  
Rep. gr.96 - Lights, bulbs, switches - intGerioEr TtheMANUALS.org  
Tiguan 2016 ➀ , Tiguan RUS 2017 ➀  
Electrical system - Edition 11.2018  
1.9  
Removing and installing front footwell  
light -K268- / -K269-  
1.9.1  
Removing and installing front left foot‐  
well light - K268-  
Removing  
– Use a flat screwdriver to push in locking lug on front left foot‐  
well light - K268- -2-.  
– Lever off footwell light -2-.  
– Release and disconnect electrical connector -1-.  
Installing  
Install in the reverse order of removal, observing the following:  
Note  
Since the footwell light is equipped with LEDs, the entire light must  
be renewed in the event of a fault.  
– Perform functional check.  
1.9.2  
Removing and installing front right foot‐  
well light - K269-  
Removing  
– Use a flat screwdriver to push in locking lug -1- at point indi‐  
cated by -arrow A-.  
– Lever off footwell light -2-.  
– Release and separate electrical connector.  
Installing  
Install in the reverse order of removal, observing the following:  
Note  
Since the footwell light is equipped with LEDs, the entire light must  
be renewed in the event of a fault.  
– Perform functional check.  
1.10  
Removing and installing front footwell il‐  
lumination bulb -L151- / -L152-  
Since the front footwell light is equipped with LEDs, the entire light  
must be renewed.  
1. Lights  
219  
theMANUALS.org