Some settings can be saved in
— Dirt: The presence of dry dust, wax, protective
films (lotus effect), traces of detergent (from the
automatic car wash system), etc., on the
windscreen can cause the rain and light sensor
to react in a negative way. less sensitive way,
later, more slowly, or not reacting at all. Regularly
clean the sensitive surface of the rain and light
sensor and check the wiper blades for damage ÿ
p. 385.
personalization function user accounts and
are changed automatically when you switch user
accounts ÿ p. 40.
Problems and solutions
Window washer fluid level too low
— Crack in the windshield: The impact of a stone
causes the windshield wipers to perform a wipe
cycle if the rain and light sensor is activated.
The sensor then detects that the sensitive
surfaces have been reduced and adapts.
Depending on the size of the impact, the
The control indicator lights up yellow.
Fill the window washer fluid reservoir at the next
available opportunity ÿ p. 335.
Malfunction in the wiper
activation behavior of the sensor may change.
The control indicator lights up yellow.
The window cleaner doesn't work.
If the window cleaner finds an obstacle on the
glass, it will try to sweep it away. If the obstacle
continues to block the operation of the window
wiper, it will stop. Remove the obstacle and switch
on the wiper again.
1. Switch the ignition off and on again.
2. If the fault persists, go to a duly qualified
specialized workshop. Volkswagen recommends
a Volkswagen dealer.
Failure in the rain and light sensor
Rear view mirrors
The control indicator lights up yellow.
General safety instructions
The window wiper does not turn on automatically in
case of rain even though the rain and light sensor is
activated.
Through the exterior mirrors and the interior mirror,
1. Switch the ignition off and on again.
the driver can observe the vehicles behind and
adapt his driving behavior accordingly.
2. If the fault persists, go to a duly qualified
specialized workshop. Volkswagen recommends
a Volkswagen dealer.
For safe driving it is important that the driver
adjusts the exterior mirrors and the interior mirror
correctly before setting off.
Abnormal operation of the rain and light sensor
Some examples of possible causes of anomalies
and false interpretations in the area of the sensitive
surface ÿ p. 8 of the rain and light sensor:
When looking through the exterior mirrors and the
interior mirror, it is not possible to see the entire area
behind and to the sides of the vehicle. These areas
that are outside the visual field are called blind spots.
Other road users and objects may be in the blind spot.
— Wiper blades in poor condition: The pre
The presence of a film or streaks of water due to
poor condition of the wiper blades can cause the
wiper operation to be prolonged, the wiping
intervals to be considerably shortened or the
wiping to become rapid and continuous.
WARNING
Adjusting the exterior mirrors and the interior
mirror while driving can distract the driver. This
can lead to accidents and serious injury.
— Insects: The impact of mosquitoes on the
windshield can cause the wipers to start operating.
· Adjust the exterior mirrors and the interior mirror
only when the vehicle is in
had.
— Traces of salt: In winter, the windscreen wipers
may work longer than normal due to the presence
of traces of salt on the windshield almost
dry.
5 N M 0 1 2 7 6 0 A J
127
Rear view mirrors
· When parking, changing lanes, overtaking or
turning, always pay close attention to the
surroundings, as other road users or objects
could also be in the blind spot.
unless advised by a doctor. Seek immediate medical
assistance.
WARNING
· Always make sure that the mirrors are adjusted
correctly and that visibility to the rear is not
reduced by ice, snow, fogging or objects.
If an automatic anti-glare rearview mirror breaks, electrolytic
fluid may leak out. This liquid attacks plastic surfaces.
· Clean it as soon as possible, e.g. eg with a sponge
wet.
WARNING
Failure to accurately estimate the distance to vehicles behind
you can lead to accidents and serious injuries.
inside mirror
you see.
· Curved mirrors (convex or aspherical) au
they increase the visual field and objects are
seen in them smaller and more distant.
Curved mirrors do not allow calculating with
accurately measure the distance to vehicles behind you, so
using them to change lanes could cause accidents and
serious injuries.
· Whenever possible, use the interior mirror to
accurately estimate the distance to vehicles
behind you or other objects.
Make sure you have enough visibility to
back.
WARNING
Automatic anti-glare rear view mirrors contain an electrolytic
fluid that could leak out if the mirror breaks.
· If it leaks out, the electrolyte fluid may irritate the
skin, eyes and respiratory organs, especially in
the case of people with asthma or similar
diseases. Immediately inhale sufficient fresh air
and exit the vehicle or, if this is not possible,
open all windows and doors.
Fig. 112 On the windscreen: automatic anti-dazzling
interior mirror.
· If the liquid comes into contact with the skin or
eyes, immediately rinse the affected part with
plenty of cold water for at least 15 minutes and
seek immediate medical attention.
If the liquid comes into contact with footwear
or clothing, rinse immediately with plenty of water for at
least 15 minutes. Before reusing the footwear or clothing in
question, clean it thoroughly.
· If liquid is swallowed, immediately rinse mouth
with plenty of water for at least 15 minutes. Do
not induce vomiting
interior mirror.
Fig. 113 On the windscreen: manual anti-glare
128
Visibility
Automatic dimming interior mirror
exterior mirrors
With the ignition on, the sensors measure the incidence of light
from behind ÿ fig. 112 1 and ahead 2
.
The interior mirror darkens automatically based on the measured
values.
When the incidence of light on the sensors is hindered or
interrupted, e.g. For example, due to a sun blind or hanging
objects, the automatic dimming interior mirror does not work or
does not work correctly. Also, the use of portable navigation
devices attached to the windshield or near the automatic dimming
interior mirror may affect the operation of the sensors ÿ .
The automatic anti-glare function is deactivated in some
situations, e.g. For example, when reverse gear is engaged.
Fig. 114 On the driver's door: rotary knob for the
exterior mirrors.
The functions of the exterior mirrors on left-hand drive vehicles
are described below. The position corresponds to the exterior
Manual dimming interior mirror
— Basic position: the lever located at the lower edge of the
mirror points forwards, towards the windscreen.
mirror on the driver's side, and the position corresponds to the
exterior mirror on the passenger's side. On right-hand drive
vehicles, it's the other way around.
— To darken the mirror, pull the lever backwards ÿ fig. 113.
1. Switch on the ignition.
2. Turn the knob on the driver's door to the desired symbol ÿ
fig. 114.
WARNING
Light from the screen of portable navigation devices can
3. Conveniently push the control in the direction of the arrows
to adjust the exterior mirror forward, backward, left or right.
cause the automatic dimming interior mirror to malfunction
and lead to an accident and serious injury.
you see.
The abnormal operation of the anti function
The exterior mirrors fold electrically towards the
vehicle ÿ .
Automatic dazzling may mean that it is not possible to use
the interior mirror to accurately gauge the distance to
vehicles behind or to other objects.
The heating of the exterior mirrors is activated. The
heating only works when the ambient temperature is
below +20 °C (+68 °F), and initially it works at full
power. After approx. 2 minutes, heats depending on
the room temperature.
Adjust the left outside mirror.
Right exterior mirror adjustment
Zero position. The outside mirror cannot be
adjusted and all features are disabled.
Activate the functions of the exterior mirrors
The following exterior mirror functions can be activated and
deactivated in the infotainment system in the vehicle settings
menu ÿ p. 41.
5 N M 0 1 2 7 6 0 A J
129
Rear view mirrors
Synchronized mirror adjustment Synchronized
WARNING
mirror adjustment simultaneously adjusts the right exterior
mirror when the left one is adjusted.
If proper care is not taken when folding or unfolding the door
mirrors, injury could result.
1. Turn the knob to the position.
· Fold or unfold the exterior mirrors only when there is no
obstacle in their travel area.
2. Adjust the left outside mirror. The right mirror will adjust
simultaneously (synchronously).
· When moving the exterior mirrors, always be careful not to get
your fingers caught between the exterior mirror and its base.
3. If necessary, correct the mirror settings
right: turn the knob to the position and adjust the right mirror.
HE.
Folding the exterior mirrors after parking
car
WARNING
If the exterior mirrors are not folded in before entering an
automatic car wash, they could be damaged.
When the vehicle is locked or unlocked from the outside, the
exterior mirrors fold in or out automatically. For this, the rotary
knob must be in the position ,
either .
· Always fold the exterior mirrors.
,
· Do not fold or unfold the electrically folding exterior mirrors by
hand, as this may damage the electrical operation of the
exterior mirrors.
If the rotary control for the electric exterior mirrors is in the
position, the exterior mirrors will remain folded.
Saving and activating the setting of the exterior mirror for the
front passenger for reversing
Do not leave the heating of the exterior mirrors on for
longer than necessary.
Otherwise it causes unnecessary fuel consumption.
1. Unlock the vehicle with the key to which you want to assign
the setting.
2. Engage the electronic parking brake.
co.
In the event of a breakdown, the electric exterior mirrors
can be adjusted mechanically
3. Switch on the ignition.
pressing his hand on the edge of the mirror.
4. Put the gear in the neutral position.
Some settings can be saved to user accounts in the
5. Engage reverse gear.
personalization function.
zation and change automatically when switching user accounts
ÿ p. 40.
6. Adjust the exterior mirror for the front passenger so that, e.g. eg,
you can see the curb well.
7. Put the gear in the neutral position.
8. Switch off the ignition.
sun protection
9. The position set for the mirror is saved and assigned to the key.
parasols
Activate the settings for the front passenger exterior mirror
for reversing
1. Turn the knob for the door mirrors to the
position for the adjustment of the exterior mirror of the
passenger.
2. With the ignition on, engage reverse gear. The passenger
exterior mirror will move to the stored position.
The front passenger exterior mirror leaves the stored position for
reverse gear when the vehicle is moving faster than approx. 15
km/h (9 mph). or if the knob is turned to another position.
Fig. 115 On the interior trim at the front of the roof: sun
visor.
130
Visibility
2024 VW Tiguan Owner's Manual
